Connected vehicles should rely on more than one data feed to determine accurate location and speed
NYCDOT’s first demonstration of the NYC Connected Vehicle Pilot Deployment's applications to the general public produces valuable lessons learned for the deployment team
Made Public Date
10/30/2018

1102

Saratoga Springs
New York
United States
TwitterLinkedInFacebook
Identifier
2018-00841

Connected Vehicle Pilot Deployment Program: Success Stories

Background

In September of 2015, USDOT selected New York City Department of Transportation (NYCDOT), Wyoming Department of Transportation (WYDOT) and Tampa Hillsborough Expressway Authority (THEA) as the recipients of a combined $42 million in federal funding to pilot next-generation infrastructure and vehicle technology under the Connected Vehicle Pilot Deployment Program.

Lessons Learned

The New York City Connected Vehicle Pilot Deployment (NYC CVPD) was demonstrated to participants at the Intelligent Transportation Society of New York (ITS-NY) Annual Meeting and Technology Exhibition in Saratoga Springs, NY on June 13 & 14, 2018. The New York City Department of Transportation (NYC DOT) offered attendees a drive along demonstration. Vehicles installed with a Dedicated Short-Range Communications (DSRC) Aftermarket Safety Device (ASD) were driven on the roadway surrounding the meeting hotel.

Multiple DSRC ASD Vehicle-to-Vehicle (V2V) applications were demonstrated:

  • Blind Spot Warning (BSW) – Alerts the driver of vehicles alongside the car as they are accelerating and passing from your left side.
  • Electronic Emergency Brake Light (EEBL) – Warns the driver of a hard braking event in front of the vehicle to encourage a deceleration. EEBL functions even when the driver's view is obstructed by other vehicles or poor visibility.
  • Forward Collision Warning (FCW) – Alerts the driver of a potential collision with a slower moving or stationary car located in the path of the vehicle.
  • Intersection Movement Assist (IMA) – Warns the driver, when approaching an intersection, if another vehicle is entering the intersection and there is a potential conflict.

This was the first demonstration to the general public offered by NYC DOT of the NYC CVPD applications, and during the course of the two days, approximately eight drive along demonstrations were performed.

Lessons Learned from the Demonstration

Use more than one data feed, e.g, augment the GNSS signals with tethering and deployment of RSUs

  • When deployed, the NYC CVPD will rely on multiple data feeds to determine location and speed. The NYC CVPD will augment Global Navigation Satellite System (GNSS) data with triangulation from the RSU signals and in addition, the ASD will be tethered to the vehicle. Tethering taps the ASD into the CANBUS to acquire speed data directly from the vehicle allowing it to make use of dead reckoning. For the demonstration, the vehicles were untethered and relied solely upon reception of GNSS signals to determine the speed and location.

Ensure there is adequate sky visibility

  • Unfortunately, the designated roadway for the demonstrations had thick tree coverage. The lack of open sky disrupted the GNSS signals and therefore the applications were unreliable. In the future, it is important to augment the GNSS signals with tethering and deployment of RSUs. At a minimum, ensure the vehicles are tested on the selected roadway prior to the event to ensure there is adequate sky visibility to allow the ASD to acquire GNSS signals.

Use a close course with sufficient length to perform all maneuvers

  • Due to the lack of sky visibility, the demonstration was moved to a secondary roadway that was not a closed course. This roadway was open to the public and was accessible by joggers, walkers, parents with strollers, golfers and dogs. Other vehicles also utilized the roadway. To ensure the safety of all the participants, ideally the roadway would be closed to the public.

    Another impact from the change in roadways was that the new course used for the demonstration was smaller than ideal to safely perform all of the maneuvers for the applications. This required "tuning" or adjusting the applications being demonstrated to operate at slower speeds – where the time-to-collision is longer and the rate of deceleration is lower - which, under normal circumstances, would lead to too many false alarms. These parameter adjustments were made during the demonstrations to both the Host and Remote vehicle speed thresholds in order to simulate the safety application effectively in the test roadway. This reinforces the need for multiple tests of the applications to ensure that the ASDs function properly in the demonstration environment.

  •  

Consider using professional drivers

  • A final lesson learned is that there are risks involved in driving members of the general public when trying to trigger the ASD safety applications. For best results, it is recommended to utilize professional drivers or provide adequate training prior to the demonstrations.

Overall, the demonstration was an excellent learning experience for the entire NYC CVPD project team and the participants were impressed by the deployment of the V2V applications.

Connected Vehicle Pilot Deployment Program: Success Stories

Connected Vehicle Pilot Deployment Program: Success Stories
Publication Sort Date
11/01/2017
Author
Glassco, Rick; James O'Hara; Barbara Staples; Kathy Thompson; and Peiwei Wang
Publisher
USDOT Office of the Secretary for Research and Deployment

(Our website has many links to other organizations. While we offer these electronic linkages for your convenience in accessing transportation-related information, please be aware that when you exit our website, the privacy and accessibility policies stated on our website may not be the same as that on other websites.)

Goal Areas

Focus Areas Taxonomy: